Current News

Current News

Home > News > 50 tons waste heat boiler for power station

50 tons waste heat boiler for power station

WNS Series Gas-fired hot water boiler

  • Capacity:0.35-14 MW
  • Work pressure:0.7-1.25 Mpa
  • Applicable fuel:Nature gas, coke oven gas, biogas, methanol, etc.
  • Applicable industry:heat supplying, hospital, hotel

WNS Series Gas-fired hot water boiler Introduction

  

  WNS series horizontal internal combustion boiler is a boiler shell type 3 passes wetback oil/gas fired boiler. After fuel is being atomized by burner, flame is full of the wave furnace and transfer heat via furnace wall, this is 1st pass; the high temperature smoke is collected in reversal chamber and then enters 2nd pass which is grooved tubes bundle area; after heat convection, air temperature gradually falls and goes to front smoke box and turn to 3rd pass, which is smooth tubes bundle area, and then enters chimney passing back smoke box and exhausted to the atmosphere.

Get a Quote

  In order to support you on your requirements, we have prepared more solutions and price. Three ways to get them:

  Contact the online customer service

  Send an email to [email protected]

  Leave your contact detail and requirements in the message box at the bottom of the page

  Our project manager and engineer will contact you within 24 hours.

  • fossil fuel power station - wikipedia

    Fossil fuel power station - Wikipedia

    vil] power generation by source [IEA, 2018] (Percentages of 24.973 TWh). Coal (38.4%). Natural Gas (23.2%). Hydro (16.3%). Nuclear fission (10.4%). Oil (3.7%). Non hydro renew. (8%). A fossil fuel power station is a thermal power station which burns a fossil fuel. In a steam turbine power plant, fuel is burned in a furnace and the hot 

    View More
  • waste heat recovery for power and heat - midwest chp tap

    Waste Heat Recovery for Power and Heat - Midwest CHP TAP

    Sep 30, 2010 Plant produced 516,442 fewer tons of CO2 when compared to other Heat recovery boiler system comprised of 16 waste PRI) owns a majority interest in, and operates, four recycled energy projects and a 50% interest.

    View More
  • waste to energy - babcock & wilcox

    Waste to Energy - Babcock & Wilcox

    B&W Waste to Energy plants successfully operating worldwide. In Europe, 50 million tons of waste is converted into valuable energy through WtE technology, Proper turbulent mixing of the flue gases in the boiler furnace provides a better 

    View More
  • waste heat recovery for power generation | industrial efficiency

    Waste Heat Recovery for Power Generation | Industrial Efficiency

    Power can be produced by using a steam cycle, an organic rankine cycle, The low temperature level of the waste heat in cement plants (200 – 400 °C) In China about 24 kilns having capacity of 2000 ton per day and above have cogeneration units with supplementary fired boilers to meet about 22 –– 36 kWh/t clinker.

    View More
  • design and analysis of a cogeneration plant using heat recovery of a

    Design and analysis of a cogeneration plant using heat recovery of a

    [9] calculated the power generation per ton clinker of the waste heat as 30.75 kWh/t. The water from the deaerator is pumped to boiler pressure and supplied to four efficiency can be interpolated between 1 MW (70%) and 50 MW (85%).

    View More
  • waste heat recovery system (whrs) - man energy solutions

    Waste Heat Recovery System (WHRS) - MAN Energy Solutions

    Waste Heat Recovery System (WHRS) for Reduction of Fuel Consumption, Emission and EEDI. 5 air energy for exhaust boiler feed-water heating. efficiency of 50% is relatively high, the. Sum Power Generation (ST/PT): 2 – 9 MWel. HP Bypass: 11.6%. Recoverly rate: 8.6% at 90% SMCR. Service steam: 1.0 ton/h.

    View More
  • waste heat recovery - alfa laval

    Waste heat recovery - Alfa Laval

    throughout the world are using about 50% more energy than necessary.. heat, the whole energy system of the plant must be analyzed, as well as the Process heat is usually generated in steam boilers and/or in.. 5,600 metric tons/year.

    View More
  • waste heat to power systems - epa

    Waste Heat To Power Systems - EPA

    May 30, 2012 generate power, and the waste heat from the power generation equipment is then 5 Based on a range of net generation efficiencies of 20 to 30 percent and annual load factors of 50 to 85 percent.. A heat recovery boiler/steam turbine WHP project at a 159,000 tons per year of CO2 emissions savings.

    View More
  • utilization of exhaust steam of waste to energy (wte) power plants for

    utilization of exhaust steam of waste to energy (wte) power plants for

    There are over one thousand waste to energy (WTE) plants operational around the world to recovery energy and generate electricity from 250 million tons of municipal solid capacity and 50% steam extraction can produce up to 5 MWh/hour of electricity plus steam as an energy source for thermal water desalination.

    View More
  • fossil fuel power station - wikipedia

    Fossil fuel power station - Wikipedia

    vil] power generation by source [IEA, 2018] (Percentages of 24.973 TWh). Coal (38.4%). Natural Gas (23.2%). Hydro (16.3%). Nuclear fission (10.4%). Oil (3.7%). Non hydro renew. (8%). A fossil fuel power station is a thermal power station which burns a fossil fuel. In a steam turbine power plant, fuel is burned in a furnace and the hot 

    View More
  • waste heat recovery for power and heat - midwest chp tap

    Waste Heat Recovery for Power and Heat - Midwest CHP TAP

    Sep 30, 2010 Plant produced 516,442 fewer tons of CO2 when compared to other Heat recovery boiler system comprised of 16 waste PRI) owns a majority interest in, and operates, four recycled energy projects and a 50% interest.

    View More
  • waste to energy - babcock & wilcox

    Waste to Energy - Babcock & Wilcox

    B&W Waste to Energy plants successfully operating worldwide. In Europe, 50 million tons of waste is converted into valuable energy through WtE technology, Proper turbulent mixing of the flue gases in the boiler furnace provides a better 

    View More
  • waste heat recovery for power generation | industrial efficiency

    Waste Heat Recovery for Power Generation | Industrial Efficiency

    Power can be produced by using a steam cycle, an organic rankine cycle, The low temperature level of the waste heat in cement plants (200 – 400 °C) In China about 24 kilns having capacity of 2000 ton per day and above have cogeneration units with supplementary fired boilers to meet about 22 –– 36 kWh/t clinker.

    View More
  • design and analysis of a cogeneration plant using heat recovery of a

    Design and analysis of a cogeneration plant using heat recovery of a

    [9] calculated the power generation per ton clinker of the waste heat as 30.75 kWh/t. The water from the deaerator is pumped to boiler pressure and supplied to four efficiency can be interpolated between 1 MW (70%) and 50 MW (85%).

    View More
  • waste heat recovery system (whrs) - man energy solutions

    Waste Heat Recovery System (WHRS) - MAN Energy Solutions

    Waste Heat Recovery System (WHRS) for Reduction of Fuel Consumption, Emission and EEDI. 5 air energy for exhaust boiler feed-water heating. efficiency of 50% is relatively high, the. Sum Power Generation (ST/PT): 2 – 9 MWel. HP Bypass: 11.6%. Recoverly rate: 8.6% at 90% SMCR. Service steam: 1.0 ton/h.

    View More
  • waste heat recovery - alfa laval

    Waste heat recovery - Alfa Laval

    throughout the world are using about 50% more energy than necessary.. heat, the whole energy system of the plant must be analyzed, as well as the Process heat is usually generated in steam boilers and/or in.. 5,600 metric tons/year.

    View More
  • waste heat to power systems - epa

    Waste Heat To Power Systems - EPA

    May 30, 2012 generate power, and the waste heat from the power generation equipment is then 5 Based on a range of net generation efficiencies of 20 to 30 percent and annual load factors of 50 to 85 percent.. A heat recovery boiler/steam turbine WHP project at a 159,000 tons per year of CO2 emissions savings.

    View More
  • utilization of exhaust steam of waste to energy (wte) power plants for

    utilization of exhaust steam of waste to energy (wte) power plants for

    There are over one thousand waste to energy (WTE) plants operational around the world to recovery energy and generate electricity from 250 million tons of municipal solid capacity and 50% steam extraction can produce up to 5 MWh/hour of electricity plus steam as an energy source for thermal water desalination.

    View More

If you are looking for related products or have any other questions, you can call our sales hotline at any time, or click the right button to consult the quotation online!






CONTACT US

  • Tel:86-13506151153
  • Office Add:No.76 Xinda Rd.,Fenshui ,Zhoutie Town,Yixing City,Jiangsu Province,China
  • E-mail:[email protected]

Privacy Guarantee

© Copy Right: WUXI ZOZEN BOILERS CO.,LTD
Hi,may I help you with products, price, etc?